Table of Contents
Advertisement
30 electrolux built-in installation
Sticking the seal in the rabbet
• Clean the rabbet in the work surface.
• Stick the one-sided self-adhesive
sealing tape supplied onto the upper
surface of the rabbet along the edg-
es of the cut-out section.
– Cut the sealing tape into four piec-
es relating to the length of the edg-
es of the rabbet.
– For the four corners of the rabbet
the ends of the sealing tapes must
be cut into mitres. Do not stick the
ends over one another.
– Stick the sealing tape flush into the
corner of the rabbet, so that no sil-
icon compound can get under the
glass ceramic when grouting.
– Don't stretch the tapes when stick-
ing them on.
• If installing flush with the work sur-
face, use the sealing tape with di-
mensions 10x3mm.
Advertisement
Table of Contents
