Table of Contents
Advertisement
2.12 Reinstalling the cover
If you installed an optical and/or floppy disk drive, remove the bay cover(s) on the
front panel assembly before reinstalling it to the chassis. To do this:
1.
Locate the bay cover locks.
2.
Press the locks outward to release
the bay cover.
3.
Push the bay cover inward, then set
it aside.
4.
Follow the same instructions to
remove the 3.5" drive bay cover.
To reinstall the front panel assembly and side cover:
1.
Insert the front panel assembly hinge-like tabs to the holes on the right side
of the chassis.
2.
Swing the front panel assembly to the left, then insert the hooks to the
chassis until the front panel assembly fits in place.
3.
Insert the six side cover hooks into the chassis tab holes .
4.
Push the side cover to the direction of the front panel until it fits in place.
5.
Secure the cover with two screws you removed earlier.
If the air duct interferes with the CPU fan, adjust the air duct accordingly.
Air.duct
Chassis.tab.holes
2-26
5
4
5
3
1
2
1
2
1
2
2
Chapter 2: Basic installation
Advertisement
Table of Contents
