Table of Contents
Advertisement
Hard.Disk.Write.Protect.[Disabled].
Disables or enables device write protection. This will be effective only if the device
is accessed through BIOS.
Configuration option: [Disabled] [Enabled]
IDE.Detect.Time.Out.(Sec).[35]
Selects the time out value for detecting ATA/ATAPI devices.
Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]
5.3.6
AHCI Configuration
This menu is the section for AHCI configuration. It appears only when you set the
item Configure SATA as from the sub-menu of SATA Configuration to [AHCI].
Main
AHCI Settings
AHCI CD/DVD Boot Time out
SATA Port1 [Not Detected]
SATA Port2 [Not Detected]
SATA Port3 [Not Detected]
SATA Port4 [Not Detected]
SATA Port5 [Not Detected]
SATA Port6 [Not Detected]
AHCI.CD/DVD.Boot.Time.out.[35]
Selects the boot time out value for ACHI CD/DVD devices.
Congifuration options: [0] [5] [10] [15] [20] [25] [30] [35]
SATA.Port1–6.[XXXX]
Displays the status of auto-detection of SATA devices.
Main
SATA Port1
Device
SATA Port1
SMART Monitoring
SATA Port1 [Auto]
Allows you to select the type of device connected to the system.
Configuration options: [Auto] [Not Installed]
SMART Monitoring [Enabled]
Allows you to set the Self-Monitoring, Analysis and Reporting Technology.
Configration options: [Disabled] [Enabled]
5-16
BIOS SETUP UTILITY
[35]
BIOS SETUP UTILITY
:Not Detected
[Auto]
[Enabled]
Some SATA CD/DVD in
AHCI mode need to
wait ready longer.
Select the type
of devices connected
to the system.
Chapter 5: BIOS setup
Advertisement
Table of Contents
