Table of Contents
Advertisement
11 Tips and tricks
Flexible Filaments
Our 3d printers can in general handle flexible filaments well. Depending on the amount of flexibility, you might need to take
some extra precautions to print it without trouble
This is a best practice:
.
Precautions
1. Ensure you use the correct slicing profiles for flexible filaments from our supported softwares.
2. Ensure the extruders are cleared from non-flexible filaments. It is essential that the filament does not experience any
obstructions in the hot-end barrel, before reaching the hot parts of the hot-end. Otherwise chances of buckling filament
inside the extruder are very high. Obstructions can occur if there has been printed with some hard filament before, make
sure it is removed from the barrel of the hot-end. This can be done by extruding some hard filament and then fully retract it
again. Easy way is to do it via the display unit. Then slowly extrude the filaflex into the hot-end.
3. Adjust filament clamping range. The extruder arm pushes filament onto the extruder drivewheel. When using flexible
filaments it might be that the filament is squashed too much causing a lot of friction and eventually it buckles and clogs the
extrusion.
http://www.felixprinters.com/downloads/1.%20Pro%20Series/2.%20FELIX%20Pro%202/2.%20Tips%20%26%20Tricks/How%20T
o%20-%20Adjust%20filament%20clamping%20range.pdf
Loading flexible filament.
Quick Start Guide FELIX Pro L/XL
.
17
Page
Advertisement
Table of Contents
