Table of Contents
Advertisement
8 Preparation for printing
Calibration.
IMPORTANT: Only PERFORM BED LEVELING after unboxing. The printer is already fully factory calibrated.
Bed leveling: This tilts the bed in the software so the distance between nozzle and bed is the same everywhere. When to do
this?:
1. After unboxing/moving printer.
2. When you see first layer printed lines are deviating from width across the print surface.
XY and Z Nozzle calibration: These calibrations align the printheads with respect to each other to get an optimal dual head print.
When to do this?
1. After exchanging a hot-end
2. When you clearly see that during dual head printing the nozzles are not aligned in x,y or height.
9
Quick Start Guide FELIX Pro L/XL
Page
Advertisement
Table of Contents
