Asus SpaceLink WL-500 Quick Start Manual

Home gateway
Hide thumbs Also See for SpaceLink WL-500:


Quick Links

SpaceLink Home Gateway
Quick Start Guide


Table of Contents

Summary of Contents for Asus SpaceLink WL-500

  • Page 1 ® SpaceLink Home Gateway WL-500 Quick Start Guide...
  • Page 2: Copyright Information

    Product warranty or service will not be extended if: (1) the product is repaired, modified or altered, unless such repair, modification of alteration is authorized in writing by ASUS; or (2) the serial number of the product is defaced or missing.
  • Page 3 Desktop/Server (Tel): +886-2-2890-7123 (English) Support Fax: +886-2-2890-7698 Support Email: Web Site: Newsgroup: ASUS COMPUTER INTERNATIONAL (America) Address: 6737 Mowry Avenue, Mowry Business Center, Building 2, Newark, CA 94560, USA General Fax: +1-510-608-4555 General Email: Technical Support...
  • Page 4: Chapter 1 - Introduction

    Chapter 1 - Introduction 1. System Requirements To begin using the SpaceLink Home Gateway , you must have the following minimum requirements: • ADSL/Cable Modem and Broadband Internet Account • An Ethernet (10Base-T or 10/100Base-TX) adapter for wired client • At least one 802.11b wireless adapter for a wireless mobile client •...
  • Page 5: Installation Procedure

    Chapter 1 - Introduction 3. Installation Procedure Follow these steps to install the SpaceLink Home Gateway . 1. Determine the best location for the SpaceLink Home Gateway . Keep in mind the following considerations: • The length of the Ethernet cable that connects the Home Gateway to the network must not exceed 100 meters.
  • Page 6: Connecting To The Spacelink Home Gateway

    Gateway and running a web browser as a configuration terminal. The connection can be wired or wireless. For the wireless connection, you need an IEEE 802.11b compatible device, e.g. ASUS SpaceLink PC Card, installed in your Notebook PC. You should also disable WEP and set the SSID to “default”...
  • Page 7 Chapter 1 - Introduction If you want to configure the SpaceLink Home Gateway or want to access the Internet through the SpaceLink Home Gateway, TCP/IP settings must be correct. Normally, the TCP/IP setting should be on the IP subnet of the SpaceLink Home Gateway.
  • Page 8 Chapter 1 - Introduction 8. SpaceLink Home Gateway Home Page A window will ask for the User name and Password in order to log in. The factory default values are “admin” and “admin”. After logging in, you will see the SpaceLink Home Gateway home page. IMPORTANT: After entering information on any page, you must click the “Save”...

Table of Contents