Table of Contents
Advertisement
This feature enables your transmitter to send a page, at a preset time, to a certain pager to
remind them of a duty required of them. For example, a busser can receive a page every 60
minutes to remind him to check the restrooms.
You can assign up to 3 different pagers to be duty alert pagers.
PROGRAMMING THE DUTY PAGER
• At the "Duty Alert" menu, press "#/Select" key to turn the duty cycle "ON" and press the
"ENTER" key.
• Enter the duty pager number and press "ENTER" key.
• Enter the cycle time (in minutes) and press the "ENTER" key.
Set Pager No:
Cycle Time
>
Min
Enter Message
>
Duty o1 Saved
Cancel:to Exit
Enter:Next PGR
6. Setting the "Out of Range" (for coasters only)
With this feature, the coasters will play a melody when taken out of range of the transmitter
to inform the guest that they are out of range and will miss their page. The melody will only
stop, when they return back within range.
Be sure that all coasters are returned before turning out of range on or off.
TURNING THE OUT OF RANGE ON
To test the coasters with out of range on, unplug the power supply, that is connected to
the transmitter. After 45 – 60 seconds, all the coasters will play a melody since they are
not receiving a signal from the transmitter. Plug in the power supply back into the
transmitter. After a few seconds, all coasters will stop playing the melody. Return all the
coasters to the charging base or plug the power supply. The coasters are ready to
receive the page with the out of range feature turned on.
Out of range>On
#to turn ON?OFF:
Are All Pagers
Returned ??
Press ENTER Key
Press ENTER
Press ENTER
(Factory Default: OFF)
Advertisement
Table of Contents
