Table of Contents
Advertisement
PLACEMENT & MOUNTING INSTRUCTIONS
DESKTOP:
You can use your transmitter with the 20 degree wedge attached or remove the wedge and lay the
transmitter flat.
WALL MOUNT
To mount your transmitter on a wall:
• Remove the plastic bracket (included) under the transmitter unit by unlocking the 2 latches.
• Place the plastic bracket against the wall and with the aid of a pencil, mark the position of the
mounting holes. (Refer to figure below). Mount the transmitter in a convenient location
where a power outlet is available.
Mark these 3
holes on to the
wall
• Drill a hole on the marked position. Install the 3 mounting screws (and use anchors where
necessary). Ensure that the screws are not fully tightened so that the unit can be easily
removed from the wall.
• Place the transmitter onto the wall (without the plastic bracket). Plug the 2-amp wall transformer
into any suitable AC outlet. Plug the power connector into the power jack on the top left hand
side of the unit. Transmitter is now ready for use. Be certain to mount the transmitter away from
phones, heat, moisture and exposed power circuits. These items can damage your system and
shorten transmission range.
System Configuration:
Your system was set at the factory and will function as soon as it is powered up.
Default setup is as follows:
Current time is set
Sleep shutdown on (battery operated pagers will be put to sleep at 1 am everyday)
Range Test is off. (Testing range is only necessary for very large properties)
Coasters are set to Flash & Vibrate when paged.
Duty Alert is off
Out of Range alert is off
*Some major points to remember when installing the equipment:
-Never install aerials near to overhead power lines or adjacent to telephone or public address or
Data communication lines.
-Avoid,where possible, running aerial feeder cables alongside other cables e.g.:telephone and
mains.
-Avoid mounting the transmitter in the immediate vicinity of telephones, exchanges or computer
equipment .
WALL
Advertisement
Table of Contents
