Related Manuals for WoodFast BS350C
Summary of Contents for WoodFast BS350C
- Page 1 Instruction Manual BANDSAW BS350C IMPORTANT： For yoursafety，read instructions carefully before assembling or using this product. Save this manual for future reference. Original Instruction： V.1-201807...
-
Page 2: Table Of Contents
INDEX GENERAL INFORMATION FOREWORD MACHINE IDENTIFICATION CUSTOMER SERVICE RECOMMENDATIONS SAFETY PRECAUTIONS SAFETY REGULATIONS RESIDUAL RISKS SAFETY AND INFORMATION SIGNALS SPECIFICATIONS MAIN COMPONENTS TECHNICAL SPECIFICATION ELECTRICAL CONNECTION NOISE LEVEL DUST EXTRACTION INSTALLATION INSTALLATION ZONE CHARACTERISTIC INSTALL OF LOOSE PARTS INTRODUCTION ADJUSTMENT AND OPERATION CENTERING TABLE AND TILTING SETTING TABLE SQUARE WITH BLADE CHANGING AND SETTING THE BLADE... -
Page 3: General Information
1. GENERAL INFORMATION FOREWORD This machine is professional for straight cutting and square cutting of wood material, especially for wood panels cutting. Some information and illustrations in this manual may differ from the machine in your possession, since all the configurations inherent in the machine complete with all the optional are described and illustrated. - Page 4 - The working area around the machine must be kept always clean and clear, in order to have an immediate and easy access to the switchboard. - Never insert materials which are different from those which are prescribed for the machine utilization. - Never process pieces which may be too small or too wide to the machine capacity.
-
Page 5: Safety Regulations
WARNING Accident caused by unqualified electrical element which connect machine and unconventional installation, manufacturer assumes no responsibility WARNING Accident cause by change machine function or change spare part arbitrarily, manufacturer assumes no responsibility WARNING Accident caused by operation under missing part or damage condition, manufacturer assumes no responsibility RESIDUAL RISKS Despite observance of all the safety regulations, and use according to the rules... -
Page 6: Specifications
11-Lock handle 4-Lower door 12-Rip fence 5-Lower wheel 13-Dust port 6-Under carriage 14-Motor 7-Table 15-Quick tension handle 8-Blade guard TECHNICAL SPECIFICATION SPECIFICATION BS350C Motor voltage 220-240V/50Hz Power 1500W Blade length 2820mm Blade width 6-19mm Max. cut depth 330mm Throat width... -
Page 7: Electrical Connection
3.3 ELECTRICAL CONNECTION - Electrical installation should be carried out by competent, qualified personnel. - The mains connection should be made using the terminal box. - Replacement of the power supply cable should only be done by a qualified electrician. WARNING To avoid electrocution or fire, any maintenance or repair to electrical system should be done only by qualified electricians using genuine replacement parts. -
Page 8: Installation
4. INSTALLATION INSTALLATION ZONE CHARACTERISTICS WARNING It is prohibited to install the machine in explosive environments. The installation zone must be selected evaluating the work space required depending on the dimension of the piec es to be machined, and taking into account that a free space of at least 800mm must be left around the machine. It is also necessary to check the floor capacity and its surface, so that the machine base is evenly resting on its four supports. -
Page 9: Adjustment And Operation
5. ADJUSTMENT AND OPERATION WARNING Handle the tools with protective gloves. CENTERING TABLE AND TILTING - Centering table can be adjusted. Loosen the four bolts which hold the lower table trunnion, and adjust freely. Place the blade in the middle of the faucet and make it be parallel to the slotted side of table. -
Page 10: Setting Cutting Height
SETTING CUTTING HEIGHT - The upper blade guide should always be set as close as practical against the work. To adjust, loosen the clamp handle B, rotate handle A to adjust upper guide close to material, tighten handle B. Fig.5.5 6.
Need help?
Do you have a question about the BS350C and is the answer not in the manual?
Questions and answers