EN 2 3139 785 31470 Technical Speci cations and Connection Facilities...
Page 3
Technical Speci cations and Connection Facilities 3139 785 31470 EN 3 1. Speci cations General: AMPLIFIER: Mains voltage : 230V for /05, /12, /51 Output power 120V/230V for /98 Front : 100W RMS / channel Rear : 75W RMS / channel Mains frequency : 50/60Hz for /98, Center...
EN 4 3139 785 31470 Measurements Setup, Service Aid & Lead Free Requirements 2. Measurements Setup, Service Aid & Lead Free Requirements...
Page 5
Measurements Setup, Service Aid & Lead Free Requirements 3139 785 31470 EN 5...
Page 6
EN 6 3139 785 31470 Measurements Setup, Service Aid & Lead Free Requirements...
Page 7
Due to lead-free technology some rules have to be respected by the workshop during a repair: Use only lead-free solder alloy Philips SAC305 with order code 0622 149 00106. If lead-free solder-paste is required, please contact the manufacturer of your solder-equipment.
Dismantling Instructions & Service Positions EN 10 3139 785 31470 4. Dismantling Instructions Dismantling of the Tuner Module, MONO Board, Front Board, PSU Module Dismantling of the DVD Loader 1) Loosen 1 screw A (see Figure 4-3) to remove the Tuner Module (pos 1040).
Page 11
Dismantling Instructions & Service Positions 3139 785 31470 EN 11 4.3 Service Positions Front Board Thick Insulation Sheet Mono Board PSU Board DVD Loader Thick Insulation Sheet...
Service Test Program EN 12 3139 785 31470 Service Test Program To start service test program refers to Service Mode open the tray with remote control refers to Version or front panel key, while plugging xx refers to Software version number of BEA in the mains cord press 2, 5 8 on (counting up from 01 to 99) remote control, the tray will close...
Page 13
Service Test Program 3139 785 31470 EN 13 5.1.4 Procedure to upgrade the rmware 5.1.1 Reprogramming of DVD version Matrix 1. Power up the set and open tray. After repair, the customer setting and region code may be lost. Reprogramming will put the set back in the state in which it has left 2.