AEG FAVORIT 34030 I User Manual page 42

Table of Contents

Advertisement

Available languages

Available languages

42
What to do if...
Malfunction
After the check, switch on the appliance. The programme continues from the point of
interruption.
If the malfunction shows again, contact the service centre.
For other fault codes, not showed in the chart, contact the service centre.
The necessary data for the service centre is on the rating plate.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the
dishes.
There are streaks, milky stains,
or a bluish layer on glasses
and dishes.
Dry water drop stains on
glasses and dishes.
Fault code
The delay start is set.
Possible cause
The selected washing pro-
gramme was not applicable
for the type of load and soil.
The baskets were not loaded
correctly, water did not touch
all surfaces.
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
The filters are dirty or not as-
sembled and installed correct-
ly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect water softener ad-
justment
The salt container cap is not
closed correctly.
Rinse aid dosage is too high.
Rinse aid dosage is too low.
Possible cause
If you want to cancel
the delay start, refer to
'Select and start a
washing programme'.
....................
....................
....................
Possible solution
Make sure that the washing
programme is applicable for
the type of load and soil.
Load the baskets correctly.
Make sure that an incorrect ar-
rangement of the load does
not cause a blockage of the
spray arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener.
Make sure that the salt con-
tainer cap is closed correctly.
Decrease the rinse aid dosage.
Increase the rinse aid dosage.
Possible solution

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents