Electrolux EWN 12791 W User Manual page 41

3. Set the hose correctly by loosening
the ring nut. After positioning the inlet
hose, be sure to tighten the ring nut
again to prevent leaks.
4. Connect the hose to a tap with a 3/4"
thread. Always use the hose supplied
with the appliance.
P1088
The inlet hose must not be lengthened.
If it is too short and you do not wish to
move the tap, you will have to
purchase a new, longer hose specially
designed for this type of use.
Important!
Before connecting the machine to new
pipework or to pipework that has not
been used for some time, run off a
reasonable amount of water to flush
out any debris that may have collected
in the pipes.
Water drainage
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink using
the plastic hose guide supplied with
In this case, make sure
the machine.
the end cannot come unhooked when
the machine is emptying. This could be
done by tying it to the tap with a piece
of string or attaching it to the wall.
installation electrolux 41
P0022
In a sink drain pipe branch.
branch must be above the trap so that
the bend is at least 60 cm above the
ground.
Directly into a drain pipe at a height
of not less than 60 cm and not more
than 90 cm. The end of the drain hose
must always be
ventilated
inside diameter of the drain pipe must
be larger than the outside diameter of
the drain hose.
The drain hose must not be kinked.
P1118
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Centre.
Electrical connection
This machine is designed to operate
on a 220-230 V, single-phase, 50 Hz
supply.
Check that your domestic electrical
installation can take the maximum load
required (2.2 kW), also taking into
account any other appliances in use.
GB
This
, i.e. the