Table of Contents
Advertisement
STEP 5 - SINK ASSEMBLY
5. Tighten the screws under the bracket so that the acorn nuts raises the sink and secures it to the stone top. Do not overtighten.
6. Verify that the stone top is level and wipe away excess silicone sealant. Allow the sealant to set according to the sealant
manufacturer's instructions.
7. Install the faucet(s) to the stone top and drain(s) to the sink(s). Refer to the faucet and drain manufacturer's instructions.
8. Complete the faucet connections. Run water and check for leaks.
5
6
7
8
3-1/4"
(83 mm)
Part no. 209-1274-rA rev. 06/06/17
Curated Cartesian H2
© 2017 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
9
Installation instructions
Advertisement
Table of Contents
Need help?
Do you have a question about the CURATED CARTESIAN VANITY and is the answer not in the manual?
Questions and answers
The slides on my vanity drawer do not operate properly. When the drawer is closed it won't open when I push it in and let go. Is there some adjustment to the slide mechanism that can fix this?
To adjust the slide mechanism on a Robern Curated Cartesian Vanity drawer that does not open properly, follow these steps:
1. Fully extend the slide rails – Pull the rails all the way out to ensure they are properly aligned.
2. Reinstall the drawer – Place the drawer back into the extended slide rails.
3. Secure the drawer – Close the drawer until you hear a series of clicks, indicating it is properly engaged.
4. Check leveling – If the drawer does not open or close smoothly, verify that the vanity frame is level and adjust if necessary.
5. Shim if needed – If the wall is bowed or uneven, shim the frame to ensure proper alignment.
6. Tighten structural bolts – Ensure that the frame bolts are securely tightened to maintain stability.
If the issue persists, check for obstructions or misaligned components in the slide mechanism.
This answer is automatically generated