Table of Contents
Advertisement
STEP 7 - ATTACHING GLASS DRAWER FRONT
1. Install 2 #8-32 x 1/2" screws (203-1219) WITHOUT washers on the bottom of each bracket in the drawer front. Do not tread all the
way through so that the screw can be hung on the keyhole in the next step, See Figure 1.
2. Hang the drawer front on the two keyholes on each side of the drawer box. See Figure 2.
3. Install the remaining screws WITH washers into the two remaining threads in the drawer front bracket as shown in Figure 3. Tighten
all screws after the drawer front is level and even with the side kits.
4. Snap the screw covers over the screws by squeezing gently at "Robern".
1
2
3
4
Part no. 209-1274-rA rev. 06/06/17
Curated Cartesian H2
© 2017 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
11
Installation instructions
Advertisement
Table of Contents
Need help?
Do you have a question about the CURATED CARTESIAN VANITY and is the answer not in the manual?
Questions and answers
The slides on my vanity drawer do not operate properly. When the drawer is closed it won't open when I push it in and let go. Is there some adjustment to the slide mechanism that can fix this?
To adjust the slide mechanism on a Robern Curated Cartesian Vanity drawer that does not open properly, follow these steps:
1. Fully extend the slide rails – Pull the rails all the way out to ensure they are properly aligned.
2. Reinstall the drawer – Place the drawer back into the extended slide rails.
3. Secure the drawer – Close the drawer until you hear a series of clicks, indicating it is properly engaged.
4. Check leveling – If the drawer does not open or close smoothly, verify that the vanity frame is level and adjust if necessary.
5. Shim if needed – If the wall is bowed or uneven, shim the frame to ensure proper alignment.
6. Tighten structural bolts – Ensure that the frame bolts are securely tightened to maintain stability.
If the issue persists, check for obstructions or misaligned components in the slide mechanism.
This answer is automatically generated