Table of Contents
Advertisement
1. Power supply unit supplied with this product must be earthed. Socket types vary between countries,
ensure that plug matches the socket correctly for the earth pin.
2. Use only an LPS rated PSU with voltage and current ratings suitable for the requirements listed on the
product label.
3. Do not block or cover ventilation openings on the back or bottom of the monitor cabinet.
4. Do not place this monitor near a radiator or heating vent.
5. Do not push objects of any kind through cabinet openings. This may result in fire or electrical shock.
6. Before adding attachments always ask a service technician to perform routine safety tests to
determine that equipment is in safe operating condition. Ground potential tests should be part of the
routine safety check made by the service technician.
7. This monitor is intended to be secured to a surface with the mounting supplied, it should not be
installed unsecured on a desktop, follow the bracket installation instructions in "Mounting" section.
8. Route power cords so that they cannot be walked upon or tripped over. Do not allow anything to rest
on the power cord.
9. This product is intended for indoor use, do not use where it may be exposed to water droplets
10. Unplug the power cord from the unit before cleaning the display. Use only a damp cloth. Do not use
alcohol, spirits, or ammonia to clean the display.
DO NOT ATTEMPT TO CLEAN THE INTERIOR OF THIS UNIT- THIS ACTION MUST BE
PERFORMED BY THE SERVICE TECHNICIAN AS REQUIRED DURING NORMAL
MAINTENANCE.
11. Refer all servicing to qualified service personnel.
REMOVAL OF BACK COVER BY UNAUTHORIZED PERSONNEL MAY EXPOSE THE USER TO
DANGEROUS VOLTAGES OR OTHER HAZARDS.
12. This product is intended for professional installation and operation.
13. The display has a dual power inputs for 24V DC, including screw terminals and a plug-in jack. DO NOT
use the supplied PSU at the same time as any other PSU.
14. If installing permanent power wiring to the screw terminals ensure it meets the requirements of
regional wiring regulations
15. Unplug the unit immediately and notify the service technician.
i.
If liquid has been spilled into the display or the display has been exposed to rain or water.
ii.
If the unit has been dropped or the cabinet damaged.
iii.
If fuses continue to blow.
iv.
If the power cord is damaged or frayed.
v.
If a distinct change from normal operation is apparent.
CAUTION: Do not attempt to dismantle this product. Any attempt to dismantle or remove the covers
from this product will invalidate the warranty and may also result in serious injury
SAFETY PRECAUTIONS
iii
Advertisement
Table of Contents
