Table of Contents
Advertisement
Problem
Scan window is not clean.
Object
scanning.
Scanning application is
not loaded.
Your
Terminal
Unreadable barcode.
doesn't
Distance between your
accept scan
terminal and the object is
input.
too far or close.
Terminal
programmed
barcode.
When
direct rays.
Terminal removed from
cradle
communications.
Incorrect
ActiveSync
figuration.
doesn't
ActiveSync
operate.
correctly
configured.
When it connects you by
Guest, not by the name
you made.
Volume setting is low or
No sound is
turned off.
audible.
Dust is in the speaker.
Terminal
Character strokes written
doesn't
incorrectly with the stylus.
recognize
Character strokes written
my
on the wrong portion of
handwriting.
the LCD screen.
Preliminary Version / January 2005
Cause
Clean the scan window with a soft cloth.
trembles
while
Be careful the object should not tremble while
scanning.
Tap Start, then Settings → Control Panel, and
select the System tab to verify the unit is loaded
with a scanning application.
Be sure the terminal cannot read spoiled
barcodes.
Adjust
approximately 6 inches, and try again.
is
not
Verify the terminal is programmed to accept the
for
the
type of barcode you are scanning.
scanning
under
Incline the barcode at an angle of 45 degrees or
scan against direct rays.
during
Replace the terminal into the cradle.
cable
con-
See if your cable is authentic, and check the
connecting status.
was
in-
installed
or
Install the ActiveSync program again.
Take the terminal out of the cradle, then replace
the terminal in the cradle and give your name
again.
Check the volume slider in Volume & Sounds
(Tap Start → Settings → Control Panel) to
ensure the volume is set to an adequate level.
Clean up the speaker.
For your terminal to recognize handwriting input
with the stylus, characters must be written in a
certain way.
Adjust the letter recognizer.
Solution
the
distance
31
between
them
by
Advertisement
Table of Contents
