Bunker Hill Security 64910 Owner's Manual & Safety Instructions page 6

Operation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
1. If needed, gently grasp the lamp heads
and tilt them up or down or side to side
to adjust the light coverage area.
2. Rotate the Motion Sensor so the
controls face the ground.
3. To increase the detection zone, slide the
sensitivity switch toward the "H" (high) position.
To decrease the detection zone, slide the
sensitivity switch toward the "L" (low) position.
Page 6 For technical questions, please call 1-888-866-5797.
4. Set the ON-TIME switch to
1, 3, 5, or 20 minute position.
5. Set the DUALBRITE switch to
OFF, 3H, 6H, or D2D (dusk to dawn).
6. After light is set up, turn the power on at the circuit
breaker or fuse and turn on any wall switch.
Item 64910