Bunker Hill Security 64910 Owner's Manual & Safety Instructions page 5

5. Route the outlet box wires through a hole in the Base.
Place the Base against the outlet box.
6. Insert the Base Screw through the hole located
in the center of the Base, and thread it into
the center hole of the Bracket. Tighten the
Base Screw securely. Firmly pull on the Base
to verify it is securely attached to the Bracket.
Base
Base Screw
7. Connect the Wires to the terminals on the Base:
• Connect the black wire from the outlet
box to the "L" terminal on the Base.
• Connect the white wire from the outlet
box to the "N" terminal on the Base.
• Connect the grounding wire (usually green/
yellow insulation) from the outlet box to
the "GND" terminal on the Base.
• Carefully tuck excess wire length
back into the outlet box.
Item 64910
Bracket
Figure D
For technical questions, please call 1-888-866-5797.
8. Align the bottom edge of the Light Fixture
with the bottom edge of the the Base. Tilt the
Light Fixture towards the Base, making sure the
Light Fixture is centered on the mounting base
and the pins within the light fixture align with the
terminal block. Secure with the Fixture Screw.
9. Push the Screw Cover firmly into
the fixture screw hole.
Screw
Cover
Fixture
Screw
10. Caulk around the Base and mounting surface
with silicone sealant (not included).
Base
Figure E
Light Fixture
Figure F
Base
Page 5