Installation Instructions - Bunker Hill Security 64910 Owner's Manual & Safety Instructions

Installation Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
DANGER! TO PREVENT SERIOUS INJURY AND DEATH FROM ELECTRIC SHOCK: Disconnect power supply
to circuit at breaker box and mark that breaker clearly to ensure it is not turned on during installation.
1. Determine the mounting location - wall or
eave mount. Position the Light Fixture in the
general direction of the desired light coverage.
Rotate the Motion Sensor so the controls
face the ground after installation.
Wall Mount
Note: Do not install the
Light Fixture upside-down,
with the Motion Sensor on top.
2. Unscrew the Fixture Screw connecting the Light
Fixture to the Base and remove the Base.
Page 4
Eave Mount
Figure A
For technical questions, please call 1-888-866-5797.
Fixture
Screw
3. Remove any existing fixture.
Use a voltage tester (sold separately) to ensure
circuit's power is disconnected before proceeding.
4. Turn the bracket so that the side marked
FRONT faces you. Install the Bracket using the
Bracket Screws that fit the outlet box. Firmly pull
on the Bracket to verify it is securely mounted
to the outlet box. If necessary, use the screws
that were removed from the existing fixture.
Light Fixture
Figure B
Bracket Screws
(new or existing)
Figure C
Item 64910
Base
Bracket