Electrolux Z2920 Series Owner's Manual page 10

To Clear Blockages in Hose
CAUTION: Turn off the switch and unplug the
electrical cord before clearing hose.
1. Firmly pull the end of the hose from the hose retainer on
the hood of the vacuum.
2. Check for blockages in the hose and hose retainer. Flexing
the hose may help loosen any blockage. If no blockage
is found, continue to step 4.
If blockage is found, clear the blockage and replace the
hose in the hose retainer. If the blockage is in the hose
retainer and cannot be cleared, continue to step 3.
10
Hose
Retainer
Hose
3. Remove the hood from the cleaner and check for a
blockage in the brush roll area. Make sure the hose inlet
is clear. If no blockage is found, continue to step 4.
After the blockage is found and cleared, replace the hood
on the cleaner.
4. Twist the hose from the coupling elbow on the back of
cleaner. Check for blockages at cleaner opening and in
hose. If a blockage is found, clear the blockage.
The screw attaching the clear hose adapter can be
removed for better access to a blockage.
5. Screw the hose back onto the back of the cleaner and
replace the other end of the hose into the hose retainer
on the hood of vacuum.