PM160
IN-EAR MONITORING SYSTEM
28
Selecting the stereo/mono operating mode
In the menu item INPUT you can select the operating mode for the audio
inputs. The loopthrough outputs and the monitor output are not affected by
the selection.
• STEREO: The audio signal of the left and right audio input (INPUT 1/L and
2/R) is transmitted to the receiver. This can either be a stereo signal or two
mono signals.
• MONO: Only the audio signal of the right audio input (INPUT 2/R) is
transmitted to the receiver. The signal is located on both channels (left/right)
of the receiver.
Selecting a standard display
In the menu item dISP you can switch between FREQ (radio frequency),
CHAN (channel) or NAME (freely selectable name) for the standard display.
Enable/disable lock mode
In the menu item LOCK you can enable/disable the lock mode.
• ON: It is not possible to switch off the unit and change the transmission
channel with the buttons ⊳ and . The display indicates .
• OFF: The lock mode is disabled. The display indicates .
Adjusting the input sensitivity
In the menu item SENSIT you can adapt the transmitter's input sensitivity to
the output signal of the audio source. The AF bargraph serves as visual aid
for the adjustment. It should only show full deflection during the loudest
passages. Increase the sensitivity by selecting LOW if the volume of the
signal is too low and a poor S/N ratio results. Reduce the sensitivity by
selecting HIGH if the volume of the signal is too high and thus distorted.
Selecting the operating mode for transmission channel adjustment
In the menu item MOdE you can select the operating mode for transmission
channel adjustment with the buttons ⊳ and .
• CHAN: One of the preset channels 132 can be selected.
• TUNE: The radio frequency can be freely adjusted in step of 25 kHz.
Adjusting the display brightness
In the menu item bRIGHT you can adjust the brightness of the display in 16
steps.