System Start-Up Test - Amana AVZC20 Installation & Service Reference

S 3. S S -
TEP YSTEM TART
NOTICE
O - ,
N INITIAL POWER START UP
E11,
SIGNALING THAT INITIAL
C N ™
THE OMFORT ET SETUP SCREEN TO ENTER APPLICATION
. S C
INFORMATION EE OMFORT
.
DETAILED INFORMATION
A system test is now required to check the equipment
settings and functionality. Once selected, it checks the
equipment for approximately 5 - 15 minutes. System test
may exceed 15 minutes if there is an error. Refer to
the Troubleshooting section.
Before starting the SYSTEM TEST, turn off the electric heater
or gas furnace.
1. Ensure the thermostat is installed.
2. Apply power to outdoor and indoor units.
3. Start-up.
After the application information is entered,
the initial system test must be run.
NOTICE
F H/P
OR INVERTER SYSTEM USING
.
TRANSFORMER
The HOME screen will be displayed showing
information similar to one of the adjacent screens.
Select MENU.
NOTE: Either screen may be displayed.
SYSTEM TEST must be run for all installations.
System will not operate without a completed initial
SYSTEM TEST.
NOTE: Ensure the thermostat is in OFF mode.
T
UP EST
THE OUTDOOR UNIT WILL DISPLAY CODE
SYSTEM . F
TEST MUST BE RUN OLLOW
-
UNIQUE
N
ET THERMOSTAT MANUAL FOR
C N , NOT
OMFORT ET DO INSTALL A
9