Cisco Catalyst 2960-XR Configuration Manual page 88

Designating the Neighbor Type
Beginning in privileged EXEC mode, follow these steps to override the default link-type setting. This procedure
is optional.
Before You Begin
A multiple spanning tree (MST) must be specified and enabled on the switch. For instructions, see Related
Topics.
SUMMARY STEPS
1. configure terminal
2. interface interface-id
3. spanning-tree mst pre-standard
4. end
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2 interface interface-id
Example:
Switch(config)# interface GigabitEthernet1/0/1
Step 3
spanning-tree mst pre-standard
Example:
Switch(config-if)# spanning-tree mst
pre-standard
Step 4
end
Example:
Switch(config-if)# end
Related Topics
Specifying the MST Region Configuration and Enabling MSTP, on page 59
Catalyst 2960-XR Switch Layer 2 Configuration Guide, Cisco IOS Release 15.0(2)EX1
74
Configuring Multiple Spanning-Tree Protocol
Purpose
Enters the global configuration mode.
Specifies an interface to configure, and enters interface
configuration mode. Valid interfaces include physical
ports.
Specifies that the port can send only prestandard BPDUs.
Returns to privileged EXEC mode.
OL-29424-01