Cisco Catalyst 2960-XR Configuration Manual page 148

Configuring LACP Hot-Standby Ports
SUMMARY STEPS
1. configure terminal
2. interface interface-id
3. lacp port-priority priority
4. end
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2
interface interface-id
Example:
Switch(config)# interface gigabitethernet
1/0/2
Step 3
lacp port-priority priority
Example:
Switch(config-if)# lacp port-priority 32000
Step 4
end
Example:
Switch(config-if)# end
Related Topics
EtherChannel Configuration Guidelines, on page 120
Default EtherChannel Configuration, on page 119
Layer 2 EtherChannel Configuration Guidelines, on page 122
Monitoring EtherChannel, PAgP, and LACP Status, on page 135
Catalyst 2960-XR Switch Layer 2 Configuration Guide, Cisco IOS Release 15.0(2)EX1
134
Purpose
Enters global configuration mode.
Specifies the port to be configured, and enters interface
configuration mode.
Configures the LACP port priority.
For priority, the range is 1 to 65535. The default is 32768.
The lower the value, the more likely that the port will be used
for LACP transmission.
Returns to privileged EXEC mode.
Configuring EtherChannels
OL-29424-01