Advertisement
(22) Select and run "4: PICTURE" → "11: ISO".
(23) When "ISO ADJ START" appears, press the [SET].
(24) Set the camera to the luminance box and press the [shutter] button.
(25) When "ADJ OK" appears, ISO adjustment is complete.
(26) Turn the camera off and then on again.
(27) Select and run "4: PICTURE" → "1: SHUT".
(28) When "SHUT ADJ START" appears, press the [SET].
(29) Set the camera to the luminance box and press the [shutter] button.
(30) When "ADJ OK" appears, shutter adjustment is complete.
(31) Turn the camera off and then on again.
(32) Select and run "4: PICTURE" → "5: KIZU".
(33) When "KIZU ADJ START" appears, press the [SET].
(34) Set the camera to the luminance box and press the [shutter] button.
(35) When "ADJ OK" appears, defect adjustment is complete.
(36) Turn the camera off and then on again.
(37) Select and run "4:PICTURE" → "6: KIZU DARK".
(38) When "KIZU DARK ADJ START" appears, press the [SET].
(39) Set the camera to the luminance box and press the [shutter] button.
(40) When "ADJ OK" appears, dark defect adjustment is complete.
3. Notes And Check Values
(1) These adjustments (ADJ) must be carried out in the OPT CENTER → SHADING → WB1 →
WB2 → ISO → SHUTTER → CCD DEFECT sequence.
(2) Before beginning defect adjustment, the camera should be turned on and left powered up for at
least 30 seconds.
4. Block Diagram
Luminance box
Matched to the target requirements
for each adjustment
Product
– 7 –
EX-ZR300
Advertisement
