Table of Contents
Advertisement
62425_user_guide
6.1.2 DC Power Input Specifications
The DC power requirements for the 9522A are summarized in Table 5
below. Note that these requirements apply to DC power measured at the
9522A multi-interface connector input.
Table 5: DC Power Input Specifications
Main Input Voltage - Range
Main Input Voltage – Nominal
Main Input Voltage – Ripple
Peak Input Current (maximum)
Main Input Active Power (average)
Main Input Standby Power (average)
6.2 Control/Digital Audio (DPL bus) Interface
6.2.1 Control/Digital Audio Interface Signal
Descriptions
The control/digital audio interface enables peripherals such as handsets
and SIM card readers to be interfaced to the 9522A. The interface
utilizes an Iridium proprietary communication bus not detailed in this fact
sheet. Details can be made available after appropriate Non-disclosure
Agreements and /or License Agreements are executed.
6.3 RS232 Data Interface
6.3.1 RS232 Data Signal Descriptions
The RS232 data interface is comprised of eight standard RS232 data,
control, and status signals plus a ground level signal reference. This
interface allows a connected Data Terminal Equipment (DTE) to utilize
the 9522A's modem functionality via AT command control. A 3-wire
RS232 Data minimal interface may also be implemented however the 9
wire interface offers better control and is the recommended
implementation.
6.3.2 Autobaud
The 9522A default is for autobaud to be enabled. Autobaud will occur on
the following characters 'a', 'A', CR (carriage return). Autobaud will also
occur on the escape sequence character, provided this is an odd
number character. Normally this is set to '+' in register S2 see AT
Command Reference for details.
6.4 Analog Audio Interface
6.4.1 Analog Audio Interface Signal Descriptions
The analog audio interface is comprised of the analog audio input and
output signals referenced to the 0V signal ground as summarized in
Table 6 below.
Table 6: Analog Audio Interface Signal Descriptions
Signal Name
MIC_AUD (pin 15)
SPKR_AUD (pin 5)
0V (pin 14, 23 and 25)
6.5 SIM Interface
An integrated SIM chip reader is provided on the 9522A. An external
SIM card reader may also be interfaced as a peripheral to the 9522A via
the DPL bus (control/audio interface). A SIM card in the external reader
will take precedence over the SIM chip in the integrated connector when
both are present.
3/23/06
Parameter
Analog audio input to 9522A
Analog audio output from 9522A
Signal ground
1:55 PM
Page 6
Value
+4.0 VDC to +4.8 VDC
4.4VDC
40 mVpp
2.5 A @ 4.4 VDC
2200 mW
570 mW
Signal Description
6
7
Advertisement
Table of Contents
