Advertisement
Using your machine
CAUTION: Test for colourfastness - Wet a white absorbent cloth with the solution. In a small hidden area of your carpet/
rugs/upholstery gently rub with the dampened cloth. Wait ten minutes and check for colour removal or bleed with a white
paper towel or cloth. If your carpet has more than one colour, check all colours.
Using the hose and SpinScrub tool
Pour required amount of
Fill the clean water/
carpet cleaning solution
solution tank with warm
into the clean water/
water (max 40'C).
solution tank.
Push hose end and
Slide SpinScrub tool over tab at end of hose until it
hose solution connector
clicks into place.
into hose and solution
connection port.
Press trigger on hose to
Squeeze trigger on the
release solution/water.
forward stroke, release
trigger on backward
stroke to recover
solution/water.
Turn wash/rinse dial
Pull down accessory hose
to 'wash'.
connector cover.
Plug into mains,
press the On/Off button
to switch on.
TIP
CAUTION: To prevent damage to wood floors and other hard floors, follow the flooring manufacturer's
cleaning recommendations. Inspect floor surface for worn, finish, bare wood or separated joints.
If it's not recommended to use the carpet washer on floors if any of these conditions exist.
IMPORTANT: Before attaching the hard floor squeegee onto carpet washer, remove tanks or make sure tanks are empty
before lying the carpet washer on its back.
Washing hard floors
Lie carpet washer on its back, line
Hook front of squeegee onto edge
up squeegee with nozzle.
of nozzle.
CAUTION: Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
Emptying the dirty water tank
Press dirty water tank
Pull and lift dirty water
release latch, pull to
tank clip to release lid.
remove dirty water tank.
Lift to remove dirty water
tank lid.
Clean the filter screen
To re-fit, tilt dirty water tank and line
located at the back of the
up onto carpet washer. Push back
dirty water tank.
until it clicks into place.
Using your machine
Push squeegee under nozzle until it
clicks into place.
Empty dirty water over
the sink. Rinse dirty water
tank and lid under water
to remove dirt/ debris.
Advertisement
