Advertisement
Using your machine
CAUTION: Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
IMPORTANT: Your dirty water tank is fitted with a float. When the dirty water tank is full, or the floorhead is not in contact
with the carpet the float will shut off the suction on the carpet washer. You will be able to hear if this has happened as the
motor noise on the machine will increase. Once the float is activated, empty the dirty water tank if full. If the dirty water tank
is not full then turn off your machine at the power switch and wait for the float to settle.
Filling the water/solution tank
Press clean water/
Twist solution tank
solution tank release
cap anti-clockwise
button, pull and lift to
and remove.
remove tank.
Tilt clean water/solution
Turn wash/rinse dial to
tank and line up onto
'wash'. The SpinScrub
carpet washer. Push tank
brushes and brushbar
back until it clicks into
deep clean your carpets
place.
with water and solution
removing dirt and stains.
Plug into mains,
press the On/Off button
to switch on.
Pour required amount of
Fill the clean water tank
carpet cleaning solution
with warm water
into tank. Tighten cap
(max 40'C).
before returning tank
to unit.
TIP
NOTE: Carpets should be dry vacuumed thoroughly before washing. For heavily soiled areas, it may be necessary to repeat
the cleaning process. Make crisscrossing strokes to the original pattern and overlap each pass.
Pour required amount of
Fill the clean water/
carpet cleaning solution
solution tank with warm
into the clean water/
water (max 40'C).
solution tank.
Press the recline
Squeeze the trigger to
pedal and pull
release solution and
handle backwards.
water mix.
Press the boost trigger to
Turn wash/rinse dial
remove tough stains.
to 'rinse'. Only water
is released to remove
solution residue.
Using your machine
Turn wash/rinse dial to
Plug into mains,
'wash'. The SpinScrub
press the On/Off button
brushes and brushbar
to switch on.
deep clean your carpets
with water and solution
removing dirt and stains.
For best results apply
water/solution on the
forward stroke and
release the trigger to pick
up water/solution on the
backward stroke.
TIP
Advertisement
