Advertisement
Using your machine
NOTE: The carpet washer should be in the upright position when using the hose or pre-treatment wand; de-activating the
SpinScrub brushes and brushbar.
Using the pre-treatment wand
Pre-treating your carpet before washing will help to remove stubborn stains. Do not saturate your carpet.
Fill the clean water tank
Pour required amount
with warm water
of carpet/pre-treatment
cleaning solution into tank.
(max 40'C).
Tighten cap before
returning tank to unit.
Push wand connector into
Plug into mains,
solution tube port.
press the On/Off button
to switch on.
Turn wash/rinse dial
Pull down accessory hose
to 'wash'.
connector cover.
15
Press and hold trigger
Leave the solution for
on pre-treatment wand,
10-15 minutes before
spraying evenly over
washing carpet.
stubborn stains.
NOTE: The carpet washer should be in the upright position when using the upholstery tool; de-activating the SpinScrub
brushes and brushbar.
Using the upholstery wash tool
Pour required amount
Fill the clean water tank
of carpet/pre-treatment
with warm water
cleaning solution into
(max 40'C).
tank. Tighten cap before
returning tank to unit.
Push hose end and hose
Slide upholstery tool over tab at end of hose until it
connector into hose and
clicks into place.
solution connection port.
Using your machine
Pull down accessory hose
Turn wash/rinse dial
connector cover.
to 'wash'.
Plug into mains,
press the On/Off button
to switch on.
Advertisement
