Realignment; 模式组合 - Kenwood TK-3230 Service Manual

TK-3230
1. Getting Acquainted
q PTT (Push to Talk) switch
Press and hold, then speak into the speaker area to trans-
mit.
w MENU key
Press to perform various functions. Press and hold while
switching the power ON to enter Setting Mode.
e CAL key
Press before making a call to alert the other party mem-
bers, or press to select a unit ID to make a call.
r
/ keys
Press to change the operating channel, to select a menu
in Setting Mode, and to perform other functions.
t Power switch/Volume control
Turn clockwise to switch the power ON and counter-
clockwise to switch the power OFF. Rotate to adjust the
volume.
y MON key
Press to monitor the current channel for activity.
u LED Indicator
Indicates the transceiver status.
i SP/MIC jacks
Lift the covers and insert the accessory's plugs here.
2. PC Mode
2-1. Preface
The transceiver is programmed by using a personal com-
puter, a programming interface (KPG-22/22A, USB adapter
(KCT-53U)) and programming software (KPG-108D).
The programming software can be used with an IBM PC
or compatible. Figure 1 shows the setup of an IBM PC for
programming.
2-2. Connection Procedure
1. Connect the transceiver to the personal computer with
the interface cable and USB adapter (when the interface
cable is KPG-22A, the KCT-53U can be used.).
4

REALIGNMENT /

Antenna
天线
Microphone
麦克风
模式组合
1. 介绍
q PTT（按下通话）开关
按住，然后对着扬声器区域讲话来进行发射。
w MENU 键
按下可执行各种功能。打开电源时按住可进入设置模式。
（经销商须启用设置模式）
e CAL 键
进行呼叫前按下可提醒其他组员，或按下来选择一个单元
ID 进行呼叫。
r
/ 键
按下可改变工作信道、在设置模式下选择菜单、执行其他
功能。
t 电源开关 / 音量控制
顺时针转动可打开电源，逆时针转动可关闭电源。转动调
节音量。
y MON 键
按下可监听当前信道的活动状况。
u LED 指示灯
显示对讲机状态。
i SP/MIC 插孔
提起盖子，将附件的插头在此插入。
Speaker
扬声器
2. PC 模式
2-1. 前言
对讲机采用个人电脑、编程接口 (KPG-22/22A，USB 适配器
(KCT-53U)) 和编程软件 (KPG-108D) 进行编程。
编程软件可以在 I B M P C 或兼容的 P C 上进行使用。图 1 给
出了 IBM PC 进行编程的设置。
2-2. 连接操作
1. 使用接口电缆和 U S B 适配器将对讲机连接到个人电脑 ( 接
口电缆为 KPG-22A 时，可以使用 KCT-53U)。