English - AEG SE 2500 Instructions For Use Manual

TECHNICAL DATA
Nominal power output .............................................................
Rated output ............................................................................
No-load speed .........................................................................
Speed under load max. ...........................................................
Self-drill screws up to max. .....................................................
Allen screws (key width) ..........................................................
Dry wall screws up to max. ......................................................
Setting range of depth gauge ..................................................
Universal reception ..................................................................
Weight without cable ...............................................................
Typical weighted acceleration in the hand-arm area ...............
Typical A-weighted sound levels:
Sound pressure level ............................................................
Sound power level ................................................................
Wear ear protectors!
Measured values determined according to EN 50 144.
SAFETY INSTRUCTIONS
Please pay attention to the safety instructions in the
attached leaflet!
Appliances used at many different locations including open
air must be connected via a current surge preventing switch.
When inserting or removing screws the workpiece should be
securely held to prevent rotation.
Always disconnect the plug from the socket before carrying
out any work on the machine.
Only plug-in when machine is switched off.
Keep mains lead clear from working range of the machine.
Always lead the cable away behind you.
When working in walls ceiling, or floor, take care to avoid
electric cables and gas or waterpipes.
SPECIFIED CONDITIONS OF USE
The screwdriver is suited for setting dry wall screws when
fixing gypsum plaster boards to wood furring or metal
furring.
Do not use this product in any other way as stated for
normal use.
MAINS CONNECTION
Connect only to single-phase a.c. current and only to the
system voltage indicated on the rating plate. It is also
possible to connect to sockets without an earthing contact
as the design conforms to safety class II.
15

ENGLISH

SE 2500 SE 4000
.........400 W ..............550 W
.........200 W ..............275 W
....0-2500 min .... 0-3600 min
-1
.......1600 min ........2100 min
-1
..........6,3 mm
...........10 mm
..............- ..................4,0 mm
.......± 3,8 mm .........± 3,8 mm
.........1/4" ................ 1/4"
..........1,6 kg ...............1,6 kg
.......< 2,5 m/s ........ < 2,5 m/s
2
...........84 dB (A) .........84 dB (A)
...........97 dB (A) .........97 dB (A)
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is
in conformity with the following standards or standardized
documents. EN 50144, EN 55014-1, EN 55014-2, EN
61000-3-2, EN 61000-3-3, in accordance with the
regulations 98/37/EC, 89/336/EEC
Manager Product Development
MAINTENANCE
The ventilation slots of the machine must be kept clear at all
times.
Use only AEG accessories and spare parts. Should
components need to be exchanged which have not been
described, please contact one of our AEG service agents
(see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered.
Please state the ten-digit No. as well as the machine type
printed on the label and order the drawing at your local
service agents or directly at: AEG Elektrowerkzeuge,
Max-Eyth-Straße 10, D-71364 Winnenden, Germany.
SYMBOLS
Always disconnect the plug from the socket
before carrying out any work on the
machine.
-1
-1
2
Volker Siegle