Table of Contents
Advertisement
User Guide
Electrical connections to the thermometer
must be made through the pre-wired plug
supplied with the thermometer or through
the plug housed in the protective jacket
back cap.
To connect either plug type to the
thermometer socket:
•
Align the red marker near the lugs of the plug with the red marker
located above the keyway in the thermometer socket.
•
Push the plug into the socket, ensuring that the locking sleeve slides
forwards, locking the plug to the socket.
To disconnect either plug type from the thermometer socket:
•
Grip the locking sleeve portion of the plug.
•
Slide the locking sleeve rearwards to release the locking mechanism and
disconnect the plug from the thermometer socket.
4.4 Connections to the LMG Signal Processor
Fig. 6 Connection Schedule for 8-way Plug and Socket
Depending upon the Landmark Graphic (LMG) signal processor operating
software version, the thermometer type selection should be set to either:
RP42 C
R4 300/600C
or
R4 Thermometer
Lugs
Keyway
Marker
Marker
Page 7
Advertisement
Table of Contents
