Optional Functions - Smeg SM1634 User's Book Manual

Smeg washing machine instructions manual

Hide thumbs

Table Of Contents

Table of Contents

START BUTTON:

After selecting the required program, press this button to start the wash

cycle. Button (A) will light up to indicate the wash cycle has started.

On completion of the wash cycle, the lit button (A) will switch off. The

door can then be opened and the clean washing removed from the drum.

PROGRAMMER KNOB "STOP":

The stop function resets the washing machine. If, for any reason, you

want to change the wash program or add more washing to the load

during the wash cycle, simply place the programmer knob in position

"STOP" (the button will start to flash). Then re-position the knob on the

new program and press the "START" button.

Warning!! only use this function if strictly necessary and then only if the program to reset has

not been running for more than 3 minutes. Before opening the door after a reset, wait 2 minutes

for the locking mechanism to release.

PRE-WASH:

Press this button and the machine will perform a prewash at the maximum

temperature of 40 C.

This function can only be used on the "COTTON" and "SYNTHETICS"

programs.

N.B. When this option is used, the detergent must also be added to

the appropriate prewash compartment.

ENERGETIC WASH:

When this button is pressed, the washing machine will run a wash cycle

at the set temperature, though with a longer duration. The button is

enabled for the "COTTON" and "SYNTHETICS" programs.

NB. The use of this function depends on the type of program selected.

Consequently, if the wash program does not include this function,

the button cannot be enabled (see "PROGRAM TABLE").

NO SPIN:

When this button is pressed, the washing machine will effect a wash

cycle without spinning. The button will light up.

MAIN FUNCTIONS