Bauer 20V Hypermax Lithium 1895C-B Owner's Manual page 9

Setting Speed
Set the desired speed by sliding the Speed Switch
(1 = Low 0-650 RPM or 2 = High 0-2000 RPM).
nOticE: Make sure Speed Switch is fully engaged
in either "1" or "2" position. Do not set in between
speeds. Do not set Speed Switch when Drill is running.
Setting Direction
1. Set direction by sliding
fully to the right (forward) or left (reverse).
2. The center position locks the Trigger, not
allowing it to be depressed or the bit to rotate.
nOticE: Make sure Direction Switch is
fully engaged in desired position. Do not set
Direction Switch when Drill is running.
attaching Belt clip
1. Attach Belt Clip using supplied Screw.
Clip may be attached to either side.
Item 64582
Direction Switch
For technical questions, please call 1-888-866-5797.
Screw
Belt clip
Page 9