Timeline, Bigsky & Mobius Mode - Strymon MultiSwitch Plus User Manual

MultiSwitch Plus
TimeLine, BigSky & Mobius Mode
This mode adds expanded preset selection control for TimeLine, BigSky, and
Mobius and dedicated Looper controls for TimeLine.
May require firmware update. Check the
Connect the included TRS cable to the EXP
1
jack of the pedal you wish to control.
Enter TimeLine, BigSky and Mobius Mode by
2
A
holding down the B and C footswitches at the
same time while connecting the TRS cable
to MultiSwitch Plus. The B and C LEDs will
flash RED to confirm the selection.
Release the footswitches. The LEDs on
3
MultiSwitch Plus will flash
configuration is complete.
All outputs carry the same signal in this mode.
4 Check the Appendix
to configure the connected pedal for use in
this mode.
- Extended Control
Compatibility Chart on pg.15
A
GREEN when
for instructions on how
for details.
B B
NOTE: MultiSwitch Plus LEDs remain unlit in
this mode. The TimeLine, BigSky and Mobius
are not capable of bidirectional communication
which is required to support MultiSwitch Plus
LED functionality.
EXP
C
+ +
C
pg 6