Preset Mode - Strymon MultiSwitch Plus User Manual

MultiSwitch Plus

Preset Mode

This mode adds the ability to select and bypass three presets on
Press a footswitch with an unlit LED to select that preset on connected pedals. Step
on the same footswitch again to bypass the pedals.
Connect the included TRS cable to the EXP
1
jack of the pedal you wish to control.
Enter Preset Mode by holding down the A
2
footswitch while connecting the TRS cable to
MultiSwitch Plus. The A LED will flash
to confirm the selection.
Release the footswitch. The LEDs on
3
MultiSwitch Plus will flash
configuration is complete.
All outputs carry the same signal in this
mode.
4 Check the Appendix
how to configure the connected pedal for
use in this mode.
Check the Compatibility Chart on pg.15
1
and a list of compatible pedals.
- Extended Control
RED
GREEN when
for instructions on
for details
supported pedals.
1
A
+
NOTE: These three presets correspond to MIDI
Program Change messages 1-2-3.
NOTE: For Volante, this is equivalent to the
presets stored on playback buttons 2-3-4. For
Sunset and Riverside, these are independent
of the preset that is associated with the FAV
footswitch, which is equivalent to MIDI PC# 0.
EXP
B
pg 4