PROCRAFT 511468 Operating Instructions Manual page 9

TROUBLESHOOTING continued..
AIR PRESSURE TOO LOW
a. Verify that the compressor is delivering at least
6 CFM @60 PSI to the tool.
b. The Regulator on the unit must be set to at least 60 PSI.
TORCH IN GOOD CONDITION
Try cutting at a slower pace, the arc may not have enough
time to cut through the work piece.
DAMAGED COMPONENTS FOUND
Replace any damaged or missing components and
reassemble carefully.
Be CERTAIN to shut off the Plasma Cutter, and disconnect
it from power and air before adjusting, cleaning, or
repairing the unit, A technician should discharge all
capacitors before performing any internal procedures.
FAST NOZZLE WEAR OR EXCESSIVE SLAG FORMATION
These two problems have similar causes and will often
appear simultaneously.
The same diagnostic procedures and remedies apply to
both.
The Amperage setting may be too high; try cutting at a
lowest setting possible for the metal being cut.
PROBLEMS REDUCED
Take into account the thickness and type of metal to be
cut before you start. Thinner materials will typically require
lower amp settings.
PROBLEMS PERSIST AT LOWEST PRACTICAL SETTING
Disconnect the Torch Cables.
Disassemble the torch assembly and inspect all internal
components.
TORCH IN GOOD CONDITION
Air supply pressure may be inadequate:
a. Verify that the compressor is delivering at least
6 CFM @ 60 PSI to the tool.
b. The Regulator on the unit must be set to at least 60 PSI
DAMAGED COMPONENTS FOUND
Replace any damaged or missing components and
reassemble carefully.
GUARANTEE PROCRAFT WARRANTY INFORMATION
Every PROCRAFT welder has been thoroughly inspected
and tested before leaving the factory. In addition to any
statutory regulations, TOOLEX warrants all of its products
against faulty workmanship and faulty material for a
twelve (12) month period from the date of purchase and
undertakes, once inspected, to repair or replace, free
of charge each product or part thereof that are faulty,
on condition that: The complete product is returned
to TOOLEX or one of its Authorised Service Centres, in
person of freight pre-paid by the consumer, and the tool is
found on examination, to be faulty from a manufacturing
defect. The product or relevant spare parts have not
been misused, neglected, or been damaged by in an
accident or the repairs are required due to normal wear
and tear. Our goods come with guarantees that cannot
be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for major failure and
for compensation for any reasonable foreseeable loss or
damage. You are also entitled to have the goods repaired
or replaced if the goods fail to be of acceptable quality and
the failure does not amount to a major failure.
PLEASE SUPPLY A COPY OF YOUR TAX INVOICE FOR
YOUR WARRANTY!
The guarantee is limited to manufacturing or machining
failures, and ceases when the parts have been
disassembled, manipulated or repaired out of works.
Page 9