Program Play (Prog); Programming Tracks; Playing The Programmed Tracks; To Stop Program Play - SPHINX Myth 9 Service Manual

SPHINX Myth 9

Program Play (PROG)

With Program Play you can change the playback of
a CD:
Only play the tracks you want to hear (and thus
skip the others).
Play certain tracks a number of times.
Change the complete playing order.
Select those tracks that exactly fill one side of a
tape.
To do this you first have to select the wanted tracks
and program them into memory. Then you can start
Program Play mode.
Note: Tracks will be played in the order of
programming.
Programming is only possible when the CD has
stopped (STOP). If you press the m PROG button
during Play mode the display will show » GO TO
STOP «, while nothing further will happen.

Programming tracks

l Press the m PROG button.
The display shows »PROGR« and the PROGRAM
indication (right) blinks.
l Select the first track with the m NEXT or m PREV
button.
The display shows under TRACK the track number.
l Press the m PROG button to store the track in
memory.
The display will show:
Under TRACK: the programmed tracks (in this
case 1...).
Under TOTAL TIME the total playing time of the
program.
In the 1-15 line all the selected tracks.
Note: To play the selected track more than once,
press the m PROG button the required number of
times.
l Select all other tracks with the same method.
After each selection the display will be updated.
Note: You can program up to 30 tracks. If you try to
program more the display will show » FULL «.
Note: If you have selected a wrong track you can
not delete it from the program. You then have to
press the m STOP button twice and redo the whole
Programming procedure.
Service Manual

Playing the programmed tracks

After you have finished programming the tracks you
can start playing the program.
l Press the m PLAY button. The PROGRAM
indication (right) will light and playing starts with the
track that has been programmed first. All selected
tracks will then be played in the order of
programming.
l You may also press the m PAUSE button. The
CD player first locates the start position of the first
programmed track and then selects Pause mode.
This might be handy when recording a tape. You
first can select the recorder to record-ready and
position the tape at the correct position. You may
start Program Play with another press on the
m PAUSE button.
Note: If you select the TOTAL REM TIME display
with the m TIME button the display will show the
remaining time for the program.

To stop Program Play

To temporarily stop Program Play: press the
m STOP button once. Pressing the m PLAY button
will resume Program Play.
To stop Program Play completely: press the
m STOP button twice.
The display then will show the same CD data as
right after placing a new CD in the tray.

Shuffle Play (SHUF)

The Shuffle Play mode lets you play the tracks in
random order during Play and Program Play modes.
The m SHUF button activates this mode (the
SHUFFLE indication will light) and random play will
start immediately.
At any time you may de-activate this mode with
another press on the m SHUF button. The playback
will continue and after the current track the next
track will now be played and not a random track.

Repeat Play (REPEAT)

The Repeat mode will repeat the selected Play
mode: Play, Program Play and Shuffle Play. There
are two options.
Repeat 1: Play will be repeated once.
Repeat: Play will be repeated continuously.
You may select the Repeat 1 mode by pressing the
m REPEAT button once: the REPEAT1 indication
will light.
With a second press you select the Repeat mode:
the REPEAT indication will now be lit.
Another press de-activates the mode.
7