Stihl TS 700 Instruction Manual page 8

English
Both the throttle trigger and the
–
throttle trigger lockout must move
smoothly – the throttle trigger must
automatically return to the idle
position.
Slide control / master control / stop
–
switch must move easily to
STOP or 0
Check that the spark plug boot is
–
secure. A loose boot can lead to
flying sparks which may ignite the
escaping fuel/air mixture – risk of
fire!
Never attempt to modify the controls
–
or safety devices in any way
Keep the handles clean, dry, and
–
free of oil and dirt – important for
good control of the cut-off machine.
For wet applications, provide
–
sufficient water
The machine should only be used if it is
in good working order – risk of accident!
Starting the engine
Move at least 3 meters away from the
place at which the machine was refueled
and never start the machine in an
enclosed space.
On even ground, ensure a firm and
secure footing and hold the power tool
firmly – the cutting wheel must not touch
the ground or any objects and must not
be in the cut.
The abrasive wheel may begin to rotate
as soon as the machine is started.
6
The machine is operated by a single
person only – do not allow anyone else
within the working area – not even when
starting.
Do not drop-start the engine – start as
described in the Instruction Manual.
After releasing the throttle trigger, the
abrasive wheel keeps on running for a
while – danger of injury due to coasting
effect!
Holding and controlling the machine
The cut-off machine may only be used
for hand-held cutting or when mounted
on a STIHL cut-off machine cart.
Hand-held cutting
Always hold the machine firmly with both
hands: Right hand on the rear handle –
even if you are left-handed. To ensure
reliable control, wrap your thumbs tightly
around the handlebar and handle.
When a cut-off machine with an abrasive
wheel rotating is moved in the direction
of the arrow, a force is produced which
causes the machine to tip sideways.
The object to be cut has to be firmly
supported. Always guide the machine
towards the workpiece, never the other
way round.
Cut-off machine cart
STIHL cut-off machines can be mounted
on a STIHL cut-off machine cart.
Guard
The adjustment range of the guard is
determined by a stop pin. Never push
the guard over the stop pin.
Set the abrasive wheel guard correctly:
Direct particles of material away from
the user and machine.
Note the direction of travel of the
abraded particles of material.
TS 700, TS 800