Assemble Mounting Bracket - CalAmp Sentry 4G-900 Pico Base Station Installation And Setup Manual

4. Align the cap ridge with slot in port and insert both screws into the cover screw holes and
insert in to corresponding screw holes located at the top-left and bottom-right of the
DC/Ethernet port.
5. Tighten the screws and secure cover to port.
3.4.4

Assemble Mounting Bracket

To assemble the mounting bracket on the Pico Base unit
1. Align the mounting brackets' four inner holes with the Pico Base installation holes, located on
the under-side of the unit (rib-side). See figure below.
2. Using a Phillips screwdriver, secure the bracket to the Pico Base unit with the four screws
and washers (supplied).
18