Cover Console Port; Assemble Poe Connector - CalAmp Sentry 4G-900 Pico Base Station Installation And Setup Manual
Hide thumbs
Also See for Sentry 4G-900 Pico Base Station:
- Operating manual (73 pages) ,
- User manual (49 pages)
Table of Contents
Advertisement
3.4.2
Cover Console Port
The Console port is only used for maintenance operations performed by authorized service
personnel and should be closed in normal conditions.
Secure the Console port with both of the (supplied) screws to the port panel. See figure below.
Note: See Appendix C – Console C for Console cable pin out.
3.4.3
Assemble PoE Connector
The DC/Ethernet connector that provides the PoE connection must be assembled as follows:
1. Insert the cap in to the DC/Ethernet port cover, with the as shown below.
2. Insert the PoE cable (not supplied) through the cap and connect it to the supplied J45
connector.
3. Snap the J45 connector into the DC/Ethernet opening.
17
Advertisement
Table of Contents
