Interfaces; Bottom Panel - CalAmp Sentry 4G-900 Pico Base Station Installation And Setup Manual

1.3

Interfaces

The unit is installed vertically, where the integrated GPS antenna is located on the
(
facing the sky). All other connections, including the optional GPS external antenna connections
are located on the
1.3.1

Bottom Panel

The interface panel supports the antenna, power and Ethernet connections.
GND
The following table provides a description of the Pico Base bottom panel connectors and ports.
Table 1. Bottom Panel Connectors
No. Connector
Name
1 ANT1
2 Console
3 DC + ETH
4 GND
5 GPS
(optional)
6 ANT2
bottom
panel.
Figure 3. Pico Base Interface Panel
Connector Cable Type
Type
N type RG 214/U
Female
RJ45 Cat5 ETH
RJ45 Cat5 ETH
1 screw #10 AWG bare
ETSI copper wire
TNC RG-59
Female
N type RG 214/U
Female
Description
RF antenna connection
Low level CLI for CalAmp
technical personnel. RS-
232
DC 1.5A + Ethernet Cat5
Grounding lug. #10 AWG
bare copper wire
Base Station
Synchronization
RF antenna connection
top panel
Connected to
external antenna or
Screwed-on omni-
directional antenna
Computer
PoE data adapter
Central earth ground,
Tower or pole chassis
Optional External GPS
antenna
external antenna or
Screwed-on omni-
directional antenna
12