Advertisement
Leica mojo3D Direct Section Control –Amazone Amatron+
After connecting a new section control cable it is important that the following settings
are checked:
Latency on and off
Section channels should be set sequentially from left to right. If this causes the
sections not to operate correctly refer to Appendix A
Channels to enter a different configuration depending on the number of sections
Channels
Channels
Channels
being used. . . .
Refer to the Leica mojo3D user manual for instructions on configuring calculating and
updating the latency values.
Appendix A – – – – Changing Section
Changing Section
Appendix A
Appendix A
Changing Section
Changing Section
7
Advertisement
