Download Print this page

Britax STEELCRAFT Y-835 SERIES Use page 13

4 in 1 portable cot

Advertisement

5. TO USE THE CHANGE TABLE
WARNINGS:
UNATTENDED.
TO PREVENT FALLS THE CHANGE TABLE SHOULD NOT BE USED
ONCE A CHILD CAN SIT UP.
NEVER PLACE A CHILD IN THE COT WHEN THE CHANGE TABLE
IS IN PLACE.
ALWAYS USE THE HARNESS WHEN USING THE CHANGE TABLE.
A Lay the change table face down with the four plastic hooks facing up.
B Connect the tubes together on either side of the change table. Insert
one tube end into the other until the pin engages. Pull on the tubes to
make sure they are locked together.
C
Pick the change table up by the plastic hooks and connect to the
outside of the portable cot short end rail as shown. +
D Rotate the change table over the portable cot and engage each of the
four clamps onto the side rails. Move the bassinet clamps slightly if
they interfere with the attachment of the change table.
E Pull the pocket flap over the end of the portable cot. Attach the plastic
clamps to the leg tubes to keep the pocket in place.
F When the change table is not in use, always fold over the end rail until
required again.
G To remove the change table, release the plastic hooks from the top
rails.
NEVER LEAVE YOUR CHILD
13

Advertisement

loading