Weather Priority Mode; Same Standby Mode - Grecom 0715 Owner's Manual

the weather radio transmitter that provides you with the strongest
signal. You can use the signal meter to help you chose the best
weather radio transmitter for your area. While operating in
Weather Radio Mode, your scanner will alert on SAME
messages that match the SAME location codes you have
entered, or all SAME messages if you do not enter any SAME
location codes.

Weather Priority Mode

Weather Priority mode samples the specified weather frequency
periodically while scanning to see if the All Hazards Warning Alert
Tone (WAT) is present. If the WAT is present, the scanner will
sound an alarm and tune to the specified weather frequency to
monitor the nature of the alert.
To activate Weather Priority Mode, follow the steps above listed
above in Weather Radio Mode to find the strongest weather
radio transmitter for your area. Once the radio is tuned to the
strongest weather radio transmitter for your location, press the
PRI
the specified weather frequency periodically for the Warning Alert
Tone (WAT). If WAT is found, the radio will sound an alarm and
monitor the weather alert audio.

SAME Standby Mode

SAME Standby Mode locks the radio on the specified weather
frequency, where it waits to receive a Specific Area Message
0715 User Manual
key on the keypad. When in Scan Mode, the radio will check
Page 55