Power Jack – Black; Restoring The Factory Defaults; Connecting And Configuring Your Router; Modem Requirements - Belkin F6D4230-4 User Manual

20929_8820-00034_F6D4230-4_Enhanced_Router_User_Manual_111008
clean.doc
Page 16 of 114
When the "router" light becomes solid again, the reset is
complete.
ii. Restoring the Factory Defaults
Press and hold the "Reset" button for at least 10 seconds,
then release it. The lights on the Router will momentarily flash.
The "router" light will begin to blink. When the "router" light
becomes solid again, the restore is complete.
K. Power Jack – Black
Connect the included 12V/1A DC power supply to this jack.
---------------------------------------------------------------------------------------------

Connecting and Configuring your Router

Verify the contents of your box. You should have the following:
• Belkin Enhanced Wireless Router
• RJ45 Ethernet Networking Cable
• Power Supply
• Belkin Setup Assistant Software CD
• User Manual on the Setup Assistant CD

Modem Requirements

Your cable or DSL modem must be equipped with an RJ45 Ethernet port.
Many modems have both an RJ45 Ethernet port and a USB connection. If
you have a modem with both Ethernet and USB, and are using the USB
connection at this time, you will be instructed to use the RJ45 Ethernet
port during the installation procedure. If your modem has only a USB port,
you can request a different type of modem from your ISP, or you can, in
some cases, purchase a modem that has an RJ45 Ethernet port on it.
Ethernet USB
Setup Assistant
Belkin has provided our Setup Assistant software to make installing your
Router a simple and easy task. You can use it to get your Router up and
running in minutes. The Setup Assistant requires that your computer be
connected directly to your Router and that the Internet connection is
[use existing lineart]