CBC MP3 User Manual page 55

52 USER MANUAL
• sensorwidth - width of sensor window (valid values defined by sensor size;
this value affects sensor frame rate)
• sensorheight - height of sensor window (valid values defined by sensor size;
this value affects sensor frame rate)
• imgleft - left coordinate of default image returned in response to the
simple request
sensor window)
• imgtop - top coordinate of default image returned in response to the
simple request
sensor window)
• imgwidth ‒ width of default image returned in response to the simple
request http://ip_address/img.jpg
window)
• imgheight - height of default image returned in response to the simple
request http://ip_address/img.jpg
window)
• imgquality ‒ quality setting of image returned in response to the simple
request http://ip_address/img.jpg
• imgres ‒ resolution of default image returned in response to the simple
request http://ip_address/img.jpg
is used to request images decimated by a factor of 2 in both directions)
• auto - iris ‒ allows to enable and disable auto-iris (valid values are on and off)
• irisgain ‒ allows to specify threshold for closing the auto-iris (valid values
are from 8 to 255)
• save ‒ saves current camera configuration (all parameter values) in the
non-volatile memory
• mac ‒ retrieves the MAC address of the camera (read-only)
• model ‒ retrieves last 4 numbers of the camera model (read-only, e.g.
MP2100 camera will return 2100)
• fwversion ‒ retrieves firmware version of the camera
• procversion ‒ retrieves version of the image processor
• netversion ‒ retrieves version of the network processor
• revision ‒ retrieves the revision code of the PCB
• factory ‒ restores camera parameters to factory defaults
http://ip_address/set?params=factory
• access to camera registers:
setreg?page=page_number&reg=register_number&val=register_value
http://ip_address/img.jpg
http://ip_address/img.jpg
http://ip_address/set?params=save
CBC (America) www.computarganz.com
(valid values should fall within
(valid values should fall within
(valid values should fall within sensor
(valid values should fall within sensor
(valid values 1 to 21)
(valid values are full and half, where half