Table of Contents
Advertisement
Maintenance
Battery Inspection
DANGER
Electrocution. Do not wear jewelry while
working on this equipment. Doing so will
result in death or serious injury.
WARNING
Explosion. Batteries emit explosive gases while charging.
Keep fire and spark away. Wear protective gear when
working with batteries. Failure to do so could result in
death or serious injury.
WARNING
Explosion. Do not dispose of batteries in a fire. Batteries
are explosive. Electrolyte solution can cause burns and
blindness. If electrolyte contacts skin or eyes, flush with water
and seek immediate medical attention.
WARNING
Risk of burn. Do not open or mutilate batteries.
Batteries contain electrolyte solution which can
cause burns and blindness. If electrolyte contacts
skin or eyes, flush with water and seek immediate
medical attention.
WARNING
Accidental Start-up. Disconnect the negative battery
cable, then the positive battery cable when working
on unit. Failure to do so could result in death
or serious injury.
WARNING
Vision Loss. Eye protection is required to avoid
spray from spark plug hole when cranking engine.
Failure to do so could result in vision loss.
WARNING
Environmental Hazard. Always recycle batteries at an
official recycling center in accordance with all local
laws and regulations. Failure to do so could result in
environmental damage, death or serious injury.
Always recycle batteries in accordance with local laws
and regulations. Contact your local solid waste collection
site or recycling facility to obtain information on local
recycling processes. For more information on battery
recycling, visit the Battery Council International website
at:
http://batterycouncil.org
20
NOTE: Remove the 5 amp controller fuse from control
panel.
An authorized operator should inspect the engine battery
monthly. At this time, the battery fluid level should be
checked using a load tester and distilled water added if
needed. Battery cables and connections should also be
inspected for cleanliness and corrosion.
(000188)
A GMP ASD should inspect the battery system once
every six months. At this time, the battery condition and
state of charge should be checked using a load test bat-
tery. Recharge or replace the battery as required.
Battery service is to be performed or supervised by per-
sonnel knowledgeable of batteries and the required pre-
cautions. Keep unauthorized personnel away.
(000137a)
Observe the following precautions when working on bat-
teries:
•
Remove watches, rings, or other metal objects.
•
Use tools with insulated handles.
•
Wear rubber gloves and boots.
•
Do not lay tools or metal parts on top of battery.
(000162)
•
Disconnect charging source prior to connecting or
disconnecting battery terminals.
NOTE: Wash spilled electrolyte down with an acid neu-
tralizing agent. A common practice is to use a solution of
1 lb (454 g) bicarbonate of soda (baking soda) to 1 gal
(3.8 L) of water. Add the bicarbonate of soda solution
(000163a)
until the evidence of reaction (foaming) has ceased.
Flush the resulting liquid with water.
NOTE: Discharge static electricity before touching the
battery by first touching a grounded metal surface.
Battery Installation and Replacement
(000130)
Explosion hazard. Never add acid to a battery.
Add distilled water only. Failure to do so could
result in death, serious injury, or equipment
damage.
(000181)
(000228)
When required, the battery must be replaced with one of
equivalent size, voltage, and CCA (cold crank amp
capacity). Contact a GMP ASD for correct battery size. A
new battery must be filled with the proper electrolyte and
be fully charged before install.
Battery cables are connected to the unit at the factory.
Proceed as follows to connect cables to battery posts.
WARNING
CAUTION
Equipment damage. Do not make battery
connections in reverse. Doing so will result
in equipment damage.
Owner's Manual for Indirect Fired Heater
(000316)
(000167a)
Advertisement
Table of Contents
