Porter-Cable PC60THP Instruction Manual page 7

"P" position. The cutting depth will increase from 0 to as
much as .079 in. (2.0 mm).
nOTE: It is recom mended that test cuts be made in scrap
wood after each re-adjustment to make sure that the
desired amount of wood is being removed by the planer.
Several shallow passes (rather than one deep one) will
produce a smoother finish.
Fig. C
Blade Guard (Fig. D)

WARNING: Cut Hazard. Do not remove guard.
Ensure that the spring loaded blade guard
working order before using the planer.
Fig. D
Planing (Figs. E, F, G)

WARNING: Wait for the cutter to stop before setting
the tool down. An exposed cutter may engage the
surface leading to possible loss of control and serious
injury.

CAUTION: Allow the tool to reach full speed before
touching tool to the work surface. Lift the tool from
the work surface before turning the tool off.
1. Hold the planer in the correct position with one hand
on the front handle 3
handle 4 as shown in fig. E.
2. Place the front of the shoe
planed, making certain that the cutting blades are not
touching the surface.
3. Push down firmly on the front handle
so that the front shoe
work surface.
3
is in proper
13
13
and the other hand on the switch
on the surface to be
5
3 of the planer
5 is ABSOLUTELY FLAT on the
4. Squeeze the trigger switch
reach full speed before touching the planer blades to
the work surface.
5. Move the tool slowly into the work and maintain
downward pressure to keep the planer flat.
nOTE: Be particularly careful to keep the tool flat at the
beginning and the end of the work surface.
PlAning TiP: For a smoother appearance, fasten a piece of
scrap wood to the end of the piece you are planing. Do not
stop planing until the cutting blades of the planer are past
your work piece and into the scrap material.
Fig. E
4
Fig. F
Fig. G
Rabbet Fence (Figs. H, I)

WARNING: Turn off and unplug the tool before
making any adjustments or removing or installing
accessories.
English
1 and allow the motor to
5
3
5