Switch Test - DaimlerChrysler LH New Yorker 1994 Electronic Service Manual

8R - 2 POWER SEATS
Fig. 2 Switch Removal

SWITCH TEST

(1) Remove switch from mounting position (Fig. 2).
(2) Using an ohmmeter, perform the switch conti-
nuity tests in Fig. 3. If there is no continuity at any of
the switch positions, replace switch.
SWITCH REPLACEMENT REMOVAL
(1) Remove left cushion side shield (Fig. 2).
(2) Disconnect wiring from switch.
(3) Depress bezel retainers and push switch from
bezel.
(4) For installation, reverse above procedure.
SEAT ASSEMBLY REMOVAL
(1) Remove adjuster attaching bolts from floor pan.
Move adjuster as required for access.
(2) Disconnect battery negative cable.
(3) Disconnect wiring harness power lead at carpet.
(4) Remove assembly from vehicle.
(5) For installation, reverse above procedure. In-
stall and torque mounting bolts and nuts to 60 to 80
N m (44 to 59 in. lbs.). Connect the battery negative
cable and check seat operation.
SEAT TRACK REMOVAL
(1) Seat removed from vehicle. Using an clean area
to place seat.
(2) Remove two seat back mounting screws and
also remove two seat back recliner screws (Fig. 4).
(3) Remove four seat track mounting screws from
cushion pan.
Fig. 3 Seat Switch Test
(4) Remove track from seat.
(5) For installation, reverse above procedure.